Usually not. In Portland and across Oregon, replacing the roof on a house with similar material is work that normally needs no building permit. The state’s exceptions changed on October 1, 2026, and now cover townhouses and attached stacked two-family dwellings, building-integrated solar roofing, and houses whose original construction had to meet locally adopted wildfire standards. Some cities’ own pages list other cases, including a full tear-off that ends with new sheathing. Here is what each source says, checked on October 7, 2026 unless noted.
The state rule
Oregon’s residential code, the Oregon Residential Specialty Code, lists work exempt from a building permit in section R105.2. That list is in Chapter 1, and Chapter 1 of the 2026 edition took effect on October 1, 2026 with no phase-in, according to the Building Codes Division’s published Chapter 1. Item 15 exempts reroofing, including replacement of any damaged roof sheathing, “where the increased dead load is 4 psf (192 Pa) or less”. Permits for reroofing are still required for:
- Townhouses and attached stacked two-family dwellings.
- Building-integrated photovoltaic roof panels and other photovoltaic roof coverings.
- Houses whose original construction had to comply with the wildfire standards of section R327 because a city or county adopted them.
Ordinary rack-mounted panels are not a roof covering, but taking them down and putting them back is solar and electrical work that may need permits of its own; the guide to replacing a roof with solar panels explains it.
What changed. The 2023 edition measured the weight of the new roofing and sheathing against 30 percent of the roof’s design live load, and required a permit for any structure in a wildfire hazard zone. The 2026 test is the increase in dead load, the weight of the roof itself, and the wildfire exception now depends on how the house was originally built. The state’s list of R327 adopters (Ashland, Bend, Deschutes County, Grants Pass and Sisters) includes no Portland-area jurisdiction.
What “damaged sheathing” covers. The exemption names replacing damaged sheathing as part of a reroof. It does not say whether a whole new deck, such as plywood laid over the spaced boards of an old wood shake roof, stays inside it; that depends on how much weight the new layers add. If your job adds a full deck, ask the building department before work starts. The cedar shake roof guide explains when that happens.
The state code is uniform across Oregon: under ORS 455.040, a city may not enforce different requirements on the same matters unless the director of the Department of Consumer and Business Services authorizes it.
Portland
The City of Portland’s residential permit guidance says reroofing with a roofing material of similar weight does not need a building permit, including the replacement of some or all existing roof sheathing. It lists three cases that do: reroofing a dwelling in one of the City’s Wildfire Zones, reroofing a townhouse, and installing building-integrated solar roofing. The state rule changed on October 1, 2026, and the City’s page still read this way when we checked on October 7, 2026, so confirm your job with Portland Permitting & Development.
A note on Wildfire Zones. Portland mapped its Wildfire Hazard Zones under City Code chapter 24.51 to limit roofing materials, and its permit page still lists them. Separately, a 2025 state law (Senate Bill 83) limited the state’s wildfire construction standards to new buildings, the Building Codes Division says replacing roofing on an existing house is not subject to them, and the 2026 state exemption ties its wildfire exception to houses originally built under a locally adopted R327. We have not found a City statement on how that affects reroofs in Portland’s zones, so if your house is in or near one, ask Portland Permitting & Development before you choose a material. More on Portland’s housing and decks is in the Portland roofing section of the homepage.
Other cities in the Portland area
| City | What the city says | Source |
|---|---|---|
| Tigard | No permit for re-roofing where the replacement roofing and sheathing stay within 30 percent of the required live load design capacity; permits for wildfire zones, townhouses and building-integrated solar. This is the state’s pre-October 2026 wording, as the City’s page read when last checked on October 4, 2026; confirm with the Tigard Permit Center | City of Tigard; see the Tigard page |
| Beaverton | Adopts the state building codes “without local amendments”, so the state rule above applies inside city limits; its adopted-codes sheet (rev. 02/26) still listed the 2023 ORSC on October 7, 2026 | City of Beaverton adopted codes; see the Beaverton page |
| Gresham | Re-roofing is on its no-permit list within a weight limit (still worded as 30 percent of the live load design capacity on October 7, 2026), where the roof is not required to be fire-resistive; a permit is required when all of the old roofing is removed and new sheathing is installed | City of Gresham; see the Gresham page |
| Lake Oswego | A permit is required for applying roofing when all of the old roofing is removed and new sheathing is installed; other exemptions follow the state code | City of Lake Oswego; see the Lake Oswego page |
| Milwaukie | Points homeowners to the state code’s list of work that needs no permit (ORSC R105) | City of Milwaukie |
| Oregon City | No reroofing statement found on the City’s site. Houses in the McLoughlin and Canemah historic districts follow a roofing-materials policy | See the Oregon City page |
| Hillsboro, Tualatin, Happy Valley | No residential reroofing statement found on the city’s site | Ask the city’s building division |
Gresham and Lake Oswego both read a tear-off that ends with new sheathing over the whole roof as permit work, while Portland counts sheathing as part of a reroof that needs none, and the state exemption itself names only damaged sheathing. If your roof will need new decking, check with your city before work starts.
City or county?
A city mailing address does not mean the city issues permits. Many ZIP codes around Portland take in unincorporated county land: Aloha (Beaverton ZIPs), Metzger and Bull Mountain (Tigard ZIPs), Oak Grove (Milwaukie), Beavercreek (Oregon City) and much of the land in Hillsboro’s ZIP codes. There, Washington County or Clackamas County is the building department. Check which applies to your lot on the county’s map before asking either one.
Vancouver, Washington
Washington has its own rules. Inside Vancouver city limits, the municipal code (VMC 17.08.090) exempts a first or second layer of roof covering on a one- or two-family house where no structural work and no sheathing repair or replacement is required. In unincorporated Clark County, re-roofing permits are required for all buildings. The Vancouver page explains where the line falls.
No permit does not mean no rules
Work that needs no permit still has to meet the code and the roofing manufacturer’s instructions. In Oregon the residential code does not allow a new layer over a roof that already has two or more layers of roofing, or over one that is water-soaked or deteriorated, so many older houses are tear-offs whatever the permit answer. The roofer must hold an active CCB license in Oregon or an L&I registration in Washington. And in Oregon, any residential job over $2,000 needs a written contract (ORS 701.305), with the Construction Contractors Board’s consumer notices.
Put the permit question in the bid: whether one is needed, who applies, and whether the fee is included. A free roof inspection is a good time to ask, and the roof replacement page lists what else a bid should say.
This page is general information, not professional advice about your specific situation. Have it assessed by a qualified professional before making decisions. Last reviewed October 7, 2026.
